I didn't run that since I can't seem to find it, not on the site or my system.
I used apt-get install libftdi-dev to get the files needed, should I get the
libftdi1 or is the serial_test.c located elsewhere?
Maurice Ampt.
________________________________________
Van: Uwe Bonnes [bon@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx]
Verzonden: vrijdag 4 november 2011 10:59
Aan: libftdi@xxxxxxxxxxxxxxxxxxxxxxx
Onderwerp: Re: Writing and reading to a FT232R
>>>>> "Ampt,Maurice" == Ampt,Maurice M L <m.ampt@xxxxxxxxxxxxxxxxx> writes:
...
Ampt,Maurice> Perhaps I'm forgetting just a simple set besides baudrate
Ampt,Maurice> and line property, thank you in advance for your response.
Did you run examples/serial_test.c. This test worked for me with the
FTDI FT232TTL board, at least with sending data. You then change that
program step by step to your needs.
Bye
--
Uwe Bonnes bon@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt
--------- Tel. 06151 162516 -------- Fax. 06151 164321 ----------
--
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to libftdi+unsubscribe@xxxxxxxxxxxxxxxxxxxxxxx
--
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to libftdi+unsubscribe@xxxxxxxxxxxxxxxxxxxxxxx
|