return code; \
} while(0);
+
/**
Internal function to close usb device pointer.
Sets ftdi->usb_dev to NULL.
ftdi->type = TYPE_BM; /* chip type */
ftdi->baudrate = -1;
- ftdi->bitbang_enabled = 0;
+ ftdi->bitbang_enabled = 0; /* 0: normal mode 1: any of the bitbang modes enabled */
ftdi->readbuffer = NULL;
ftdi->readbuffer_offset = 0;
ftdi->index = 0;
ftdi->in_ep = 0x02;
ftdi->out_ep = 0x81;
- ftdi->bitbang_mode = 1; /* 1: Normal bitbang mode, 2: SPI bitbang mode */
+ ftdi->bitbang_mode = 1; /* when bitbang is enabled this holds the number of the mode */
ftdi->error_str = NULL;
}
/**
- Opens a ftdi device given by a usb_device.
+ Opens a ftdi device given by an usb_device.
\param ftdi pointer to ftdi_context
\param dev libusb usb_dev to use
return rtn;
}
-/*
+/**
ftdi_convert_baudrate returns nearest supported baud rate to that requested.
Function is only used internally
\internal
\retval 0: no data was available
\retval >0: number of bytes read
- \remark This function is not useful in bitbang mode.
- Use ftdi_read_pins() to get the current state of the pins.
*/
int ftdi_read_data(struct ftdi_context *ftdi, unsigned char *buf, int size)
{
}
/**
- Enable advanced bitbang mode for FT2232C chips.
+ Enable/disable bitbang modes.
\param ftdi pointer to ftdi_context
\param bitmask Bitmask to configure lines.
HIGH/ON value configures a line as output.
- \param mode Bitbang mode: 1 for normal mode, 2 for SPI mode
+ \param mode Bitbang mode: use the values defined in \ref ftdi_mpsse_mode, use BITMODE_RESET to switch off bitbang
\retval 0: all fine
\retval -1: can't enable bitbang mode
usb_val = bitmask; // low byte: bitmask
usb_val |= (mode << 8);
if (usb_control_msg(ftdi->usb_dev, FTDI_DEVICE_OUT_REQTYPE, SIO_SET_BITMODE_REQUEST, usb_val, ftdi->index, NULL, 0, ftdi->usb_write_timeout) != 0)
- ftdi_error_return(-1, "unable to configure bitbang mode. Perhaps not a 2232C type chip?");
+ ftdi_error_return(-1, "unable to configure bitbang mode. Perhaps selected mode not supported on your chip?");
ftdi->bitbang_mode = mode;
- ftdi->bitbang_enabled = (mode == BITMODE_BITBANG || mode == BITMODE_SYNCBB)?1:0;
+ ftdi->bitbang_enabled = (mode == BITMODE_RESET) ? 0 : 1;
return 0;
}
/**
- Directly read pin state. Useful for bitbang mode.
+ Directly read pin state, circumventing the read buffer. Useful for bitbang mode.
\param ftdi pointer to ftdi_context
\param pins Pointer to store pins into