Hello, Stefan,
I also met the problem of the mode limitation in d2xx programming, the
device I use is FT2232, and I need the SPI could be run under the mode of
CPOL = 0 and CPHA =1, until now I still did not find a way to figure it out.
Have you found some solution for the problem?
Thank you so much for your consideration.
Best Regards,
Elber
--
View this message in context:
http://libftdi.141977.n3.nabble.com/only-two-of-four-SPI-modes-supported-by-FT4232H-tp2527060p2903210.html
Sent from the libFTDI mailing list archive at Nabble.com.
--
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to libftdi+unsubscribe@xxxxxxxxxxxxxxxxxxxxxxx
|