I am using Python to configure and drive the FT232H from Adafruit. I am using
the Adafruit library as well. After realizing libusbk would not work, I
installed WinUSB from Zadig. However, I found that the connection only
worked once; subsequent attempts to connect to the chip threw errors.
Deleting all the drivers and reinstalling WinUSB would 'reset' it, and the
chip would connect for one attempt again. What is the source of this issue?
I'm on Windows 10 64 bit and running Python 2.7 on 32 bit.
--
Sent from: http://libftdi.141977.n3.nabble.com/
--
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to libftdi+unsubscribe@xxxxxxxxxxxxxxxxxxxxxxx
|
