carl-daniel wrote:
> On 05.06.2009 23:12, Paul Fox wrote:
> > i'm using one of the module's MPSSE blocks to drive a SPI interface.
> >
>
> Do you have any example code I could look at? Unfortunately, I didn't
> find docs on how to set polarity, endianness etc for SPI.
i'm getting there, slowly. i can do a RDID command and identify
our winbond flash part. i can send you that much if you'd like -- i'd
like to clean it up just a tad.
i believe you and richard smith have corresponded about this
project before -- we're trying to put together a programmer based
on the 4232H to do ISP programming of the XO laptop. i'm fitting
my changes into flashrom, but as i think you know, it's pretty
geared toward hosted self-programming, and being able to map in
the area being programmed. i'm hoping you have a better idea of
how pull in programmers like this one than i do. :-)
paul
=---------------------
paul fox, pgf@xxxxxxxxxxxxxxxxxxxx (arlington, ma, where it's 57.2 degrees)
--
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to libftdi+unsubscribe@xxxxxxxxxxxxxxxxxxxxxxx
|
