Hello Uwe Bonnes,
Sorry for the late reply.
For some reason the email response to this thread is being blocked.
Would it be possible to share an example where such setup is handled.
Thanks in advance, I would like to programmatically allow it to be in a
consistent state so as not physically keep removing and attaching the device.
On Sat, May 24, 2025 at 12:49 PM Ameya Vikram Singh
<ameya.v.singh@xxxxxxxxx> wrote:
>
> Hello,
>
> I have a FPGA development board with FT232HL chip interfaced.
> I am currently running into an issue as soon as I flash/program the
> board, the UART interface disappears.
>
> I can replicate the same behavior with the simple.c example under the
> ftdi sources.
> Does the library support FT232HL?
> Is there a way I can get back the UART interface connected to the
> system programmatically?
> I tried other examples to no success.
> Currently I have to physically remove the device and re-connect it to
> the system.
> --
> Regards,
> Ameya
--
Regards,
Ameya Vikram Singh
--
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to libftdi+unsubscribe@xxxxxxxxxxxxxxxxxxxxxxx
|
