Hello all,
I am trying out the libftdi for the first time.
After a hardware reset of the FT232BL, I poll the modem status and I get this value 0x7001 (unsigned short). The file ftdi.c says that the first four bits of the first byte must be 0.
" Layout of the first byte:
- B0..B3 - must be 0"
What does this mean when bit 0 is set at 1 instead of 0?
Thank you.
Pierre
libftdi - see http://www.intra2net.com/en/developer/libftdi for details.
To unsubscribe send a mail to libftdi+unsubscribe@xxxxxxxxxxxxxxxxxxxxxxx
|